RIFLE MOUNTS WEAVER N Manual

Pulsar Weaver N mounts are designed for installation of digital and thermal imaging riflescopes on a hunting shotgun.

The mounts are compatible with the mounting prism of the Trail 1-3, Digisight / Digisight Ultra, Apex riflescopes.

The length of Weaver N mounts – 183 mm.

The distance between the centers of the screws securing the mount to the weapon rail (Weaver/Picatinny) is 87 mm.

• Mount
• Mounting screws (5 screws М6х12)
• Allen key (S4)
• User manual
• Warranty card

Important

• Mounting slots in the riflescope base allow you to install the mount into one of several positions. Choosing the position of the mount helps to ensure correct eye relief, depending on the type of hunting shotgun.
• Weaver N mounts can be attached using either two, three or five screws depending on the riflescope model and the selected mount position.

Installation

1. Attach the mount to the riflescope base using an S4 Allen key and screws (clamping force – 4 Nm/35.4 in-lbs).
2. Mount the riflescope on the weapon rail and make sure the chosen position is comfortable.
3. Remove the riflescope from the weapon rail.
4. Unscrew the screws one by one, apply a drop of Loctite and screw back until it stops (clamping force – 4 Nm/35.4 in-lbs). Allow the Loctite to dry for some time.
5. Install the mount with riflescope on the weapon rail. Recommended torque force for the side screws is 2 Nm to 3 Nm (17.7 in-lbs to 26.6 in-lbs).
6. The riflescope is ready for zeroing.

Updates of the Product. The manufacturer reserves the right at any time, without mandatory prior notice to the Customer, to make changes to the package contents (subject to the applicable laws, if any), design and characteristics that do not impair the quality of the Product.

Limitation of Liability. Subject to mandatory applicable laws and regulations: manufacturer will not be liable for any claims, actions, suits, proceedings, costs, expenses, damages or liabilities (if any), arising out of the use of this product. Operation and use of the product are the sole responsibility of the Customer. Manufacturer’s sole undertaking is limited to providing the product(s) and related services in accordance with the terms and conditions of concluded transactions, including provisions established in warranty. The provision of products sold and services performed by Manufacturer to the Customer shall not be interpreted, construed, or regarded, either expressly or implied, as being for the benefit of or creating any obligation toward any third party (other than Distributor, Dealer, Buyer). Manufacturer’s liability hereunder for damages, regardless of the form or action, shall not exceed the fees or other charges paid to Manufacturer for the product(s) and/or service(s).

MANUFACTURER WILL NOT BE LIABLE FOR LOST REVENUES OR INDIRECT, SPECIAL, INCIDENTAL, CONSEQUENTIAL, EXEMPLARY, OR PUNITIVE DAMAGES, EVEN IF THE MANUFACTURER KNEW OR SHOULD HAVE KNOWN THAT SUCH DAMAGES WERE POSSIBLE AND EVEN IF DIRECT DAMAGES DO NOT SATISFY A REMEDY.

For technical support please contact support@pulsar-vision.com.​

Answers to frequently asked questions about the devices can also be found in the FAQ section.